![]() ![]() If you are cutting a thicker or denser material and it is not cutting through after increasing other settings, you may wish to increase the number of Passes in order to provide a cleaner or more complete cut. For some thicker materials, such as Chipboard, it may be increased as needed. It has a default setting of "1" for most materials. It is alternately labeled as "Double Cut" in lower software versions.) This number tells the machine how many times it should cut the design. Passes/Double Cut - ( This setting is labeled as "Passes" for software version 4.0 and above.If the blade is not cutting all the way through the material, or just scoring the surface, you can increase the force to achieve a better result. If your material is tearing and cutting too deeply, you will want to reduce the Force. It is alternately labeled as "Thickness" in lower software versions.) This setting controls how hard the blade is pressing down. Force - ( This setting is labeled as "Force" for software version 4.0 and above.You may wish to lower the Speed level if you are finding that certain parts of the design are tearing (most often in the corners of the design), or if the material is being lifted from the backing during the cutting process. ![]() ![]() ![]() Faster levels are available to make the overall cutting process to go faster. Speed - This setting controls the speed at which the machine operates, meaning the left/right movement of the blade carriage as well as the in/out movement of the roller bar feeding the mat/material in and out of the machine.All other blade models need to be adjusted manually to the recommended or selected level prior to loading them into the machine. If using an AutoBlade, your AutoBlade will automatically adjust to the number displayed in the software. You will want to ensure the correct tool is selected in the SEND panel as well. You can then adjust the blade setting until enough of the blade is revealed so that it is as deep as OR extends just beyond the depth of the material. If there is no common material type listed in the software for your material, you can determine a good starting point by placing the blade next to your target material so that the cap is flush with the material surface. It is recommended to use the setting found in Silhouette Studio as a starting point when using common material types. If your cuts are too deep, you can reduce the blade number and decrease the exposed blade tip. The higher the number, the more blade that will be exposed, and therefore the deeper your cut will be. Blade Number - This setting indicates the amount of blade exposed from the blade tip in 0.1 mm increments. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |